Troubleshooting - D-Link DSM-750 - MediaLounge High-Definition Draft N Media Player User Manual

Section 5 - Troubleshooting
I cannot see the Setup Wizard when I turn on my DSM-750 player for the first time.
 Make sure your TV is displaying the appropriate video source. You may need to use the AV Input, Source, Select,
or TV/Video button on your TV or TV remote to change video sources. If you are having trouble changing the video
source, refer to the instructions that came with your TV.
 If you did not connect the player directly to your TV, but are instead passing the signal through your VCR, make
sure your VCR is displaying the appropriate video source. You may need to use the Input or Source button on
your VCR or VCR's remote control. Some VCRs only pass the signal through when they are turned off. If you are
having trouble displaying the correct video source, refer to the instructions that came with your VCR.
 Make sure cables are connected to the IN jacks on your TV or VCR, not the OUT jacks.
 The cables you are using to connect your receiver to your TV or other equipment may be damaged or defective.
Try exchanging the cables connected to the receiver with other cables that you know are working properly.
 Verify the power cord is plugged into a working power outlet and that the outlet is not controlled by a light
switch.
My remote control isn't working.
 Make sure the batteries are inserted correctly.
 Try removing the batteries and reinserting them without touching any buttons on the remote control.
 Replace the batteries with new ones.
D-Link DSM-750 User Manual

Troubleshooting

110