Table of Contents
Advertisement
OTHER FEATURES
For example, if you record a 30-minute program at the
beginning of the tape and you want to go to the end of
that program to begin another recording, you would:
1. Press INFO twice to display the time counter.
2. Press CLEAR to reset the time counter to 0:00:00.
3. Press FWD to forward the tape until the time counter
reads 0:30:00.
4. Press STOP. This is the approximate end of the program.
(You may want to press PLAY to verify.) Now, you can
begin recording at this spot.
5. Press INFO to remove the time counter from the
screen and return to the normal display mode.
On-screen Displays
The INFO button shows the status of the VCR (STOP, PLAY,
RECORD, etc.), channel number, time counter, date, time, and
tape speed on the TV screen. The date and time must be set
before they can be displayed.
1. Press INFO to see the on-screen displays.
2. Press INFO again to have only the time counter remain
on the screen.
3. Press INFO again to remove the time counter from the screen.
Turning off the VCR also resets the displays.
Audio Set-up Features
The audio set-up features enhance your tape playback and
recordings. The features in this section are accessed through the
AUDIO menu and are shown in the displays below.
1. Press MENU to display the VCR MAIN MENU.
VCR MAIN MENU
1 VCR Plus+
2 Timer Recodings
3 Time
4 Channels
5 Setup
6 Preferences
7 Audio
8 Language
0 Exit
2. Press 7 to display AUDIO menu.
50
HOURS
MINUTES
Timer Counter on-screen display shows hours,
minutes and seconds of a segment of tape.
1
Stop
Ch 05
HOURS
MINUTES
11/18/99 Thu 01:30PM SLP
On-screen display (times out)
2
HOURS
MINUTES
Time counter only (does not time out)
SECONDS
0:30:00
SECONDS
SECONDS
Advertisement
Table of Contents
