Kenmore 37100 - Twilight Upright Vacuum Owner's Manual page 13

i lU u lUUUl,,
WARNING
Electrical Shock and Personal
Injury Hazard
Disconnect electrical supply
before servicing or cleaning
the unit, Failure to do so could
result in electrical shock or
personal injury from vacuum
cleaner suddenly starting.
TO REMOVE LIGHT BULB
1. Disconnect power cord from etec_cal outlet
2. Press handle release pedal and lay
vacuum cleaner back.
3. Remove the two
(2) screws from the
lens cover.
4. insert flat blade of
screwdriver into slot
at top of the lens.
Lift the lens cover to
remove.
Gather the cord and wrap it loosely around
CAUTION
Do not use a bulb rated over 9W
(13V), During extended use, heat
from the bulb could overheat
surrounding plastic parts.
5, Pull bulb out of
_ ocket° Do NOT
twist. Gently push
replacement bulb into
socket to replace..
6. Snap lens cover
back into place and
secure the headlight
lens by replacing the
two screws.
Note: See separate PARTS LIST for bulb
number,,
the upper and lower cord hooks° Lock
power cord plug onto the power cord,,
Store the vacuum
cleaner in a dry,
indoor area, on the
floor with the handle
locked in the upright
position.
WARNING
Electrical Shock and Personal
Injury Hazard
Wrapping the cord too tightly puts
stress on the cord and can cause
cord damage.
ii ....................
I3