Table of Contents
Advertisement
ServeRAID-8i
slot
1. Read the safety information that begins on page v and "Installation
guidelines" on page 21.
2. Turn off the server and peripheral devices, and disconnect the power cords.
Remove the cover (see "Removing the cover and bezel" on page 23).
3. Remove all the cables from the connectors on the I/O board.
4. Touch the static-protective package that contains the adapter to any
unpainted surface on the outside of the server; then, grasp the adapter by the
top edge or upper corners of the adapter and remove it from the package.
5. Remove the ServeRAID-8i adapter from the package, using the plastic
handle.
Attention:
Incomplete insertion might cause damage to the server or the
ServeRAID-8i adapter.
6. Position the ServeRAID-8i adapter so that the metal locking clasp is at the
rear of the server; then, press the ServeRAID-8i adapter firmly into the
connector.
If you have other options to install or remove, do so now; otherwise, go to
"Completing the installation" on page 47.
ServeRAID-8i adapter
Chapter 2. Installing options
27
Advertisement
Table of Contents
