Page 3
Press the ejectors on the RAID controller DIMM socket (see Figure 1-1) down and outward to allow the dual in-line memory module (DIMM) to be inserted into the socket (see Figure 1-2). Dell PowerEdge 2400 Systems—Activating the Dell PowerEdge Expandable RAID Controller 2/Si...
Page 5
Install the RAID hardware key in its socket on the system board (see Figure 1-1). Secure the key with the latches on each end of the socket (see Figure 1-3). The RAID hardware key should be labeled “PE2400.” Dell PowerEdge 2400 Systems—Activating the Dell PowerEdge Expandable RAID Controller 2/Si...
Page 6
11. If the Onboard RAID option is displayed, select this option. If the Primary SCSI option is displayed, the integrated RAID controller was not detected; go to step 1 and repeat all installation steps. Dell PowerEdge 2400 Systems—Activating the Dell PowerEdge Expandable RAID Controller 2/Si...
Page 7
13. Press <Alt> <b> to save the settings and reboot the system. 14. Configure the RAID subsystem and install the RAID driver and management software. For more information, refer to the integrated PERC 2/Si controller documentation. Dell PowerEdge 2400 Systems—Activating the Dell PowerEdge Expandable RAID Controller 2/Si...