Advertisement
6. Drop the heat sink clip into the heat sink's center groove with the end of the clip that has
two slots facing the front of the ZIF socket.
7 .
Gently hold the heat sink in place as you press down on the shorter end of the heat sink
clip (the end that has a single slot) until that end snaps into its tab on the back of the ZIF
socket (see Figure 1).
8. Use your thumb to press down on the front end of the heat sink clip (the end that has
two slots) until it snaps into the socket tab.
9. Replace the cover, install the power cord, and reboot the computer.
____________________
Information in this document is subject to change without notice.
© 2000 Dell Computer Corporation. All rights reserved. Printed in the U.S.A.
Trademarks used in this text: Dell, the DELL E COM logo, and PowerApp are trademarks of Dell Computer Corporation. Other
trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their
products. Dell Computer Corporation disclaims any proprietary interest in trademarks and trade names other than its own.
ZIF socket
ZIF socket
release lever
heat sink clip
microprocessor and
heat sink assembly
tabs on ZIF socket (2)
Advertisement
