Dell DX6012S Hardware Owner's Manual page 98

3 Remove the cooling shroud. See "Removing the Cooling Shroud" on page 72.
4 Remove the plastic filler plug of the iDRAC6 Enterprise port from the
system back panel.
5 Angle the card so that the RJ-45 connector fits through the back-panel
opening. See Figure 3-15.
6 Align the front edge of the card with the two front plastic retention
standoffs next to the iDRAC6 connector on the system board, and lower
the card into place. See Figure 3-15.
When the front of the card is fully seated, the plastic standoffs snap over
the edge of the card.
Figure 3-15. Installing or Removing an iDRAC6 Enterprise Card
6
1 VFlash SD card
3 iDRAC6 Enterprise card
5 retention standoff tabs (2)
102
Installing System Components
4
5
2 VFlash media slot
4 retention standoff posts (2)
6 iDRAC6 Enterprise card connector
1
2
3