Installing A Hard-Drive Blank; Removing A Hot-Swap Hard Drive - Dell DX6012S Hardware Owner's Manual

Figure 3-5. Removing or Installing a Hard-Drive Blank
1
1 hard-drive blank

Installing a Hard-Drive Blank

Align the hard-drive blank with the drive bay and insert the blank into the
drive bay until the release lever clicks into place. See Figure 3-5.

Removing a Hot-Swap Hard Drive

1 If applicable, remove the front bezel. See "Removing the Front Bezel" on
page 69.
2 Prepare the drive for removal. Wait until the hard-drive indicators on the
drive carrier signal that the drive can be removed safely. See "Back-Panel
Features and Indicators" on page 15.
If the drive has been online, the green activity/fault indicator flashes as
the drive is powered down. When the drive indicators are off, the drive is
ready for removal.
3 Press the release button and open the drive carrier release handle to
release the drive. See Figure 3-6.
4 Slide the hard drive out of the drive bay.
5 Insert a drive blank in the vacated drive bay. See "Installing a Hard-Drive
Blank" on page 74.
CAUTION:
have hard-drive blanks installed.
74
Installing System Components
2
To maintain proper system cooling, all empty hard-drive bays must
2 release lever