Canon CanoScan D1230UF User Manual page 13

Film Mode
If [Sleeve] is selected in the Scan frame type, then you can set the [Frame select button].
Determines whether or not the scanner
driver starts (only applicable to the save
and scan (1-3) functions.
If [Expert scanning] is selected, the scanner driver
will start after you close the dialog. If [Quick and
easy scanning] is selected, the scan will start
directly after simple step settings.
Film type
Select from among Color Negatives, Color
Positives, Monochrome Negatives, and
Monochrome Positives. ScanGear Toolbox only
supports 35 mm film (strips or slides).
Image quality
Select a dpi setting from 150/300/600/720/
1200/2400.
Scan frame type
(Your scanner model and optional equipment
will determine whether or not this category
appears.)
Select Sleeve or Mount.
Frame select button
You can select the frame(s) for scanning. If
more than one is selected, the selected function
(fax, copy, etc.) will be repeated as many times
as the number of frames selected. Please note
that with consecutive scans, the spaces
between frames on the film may be scanned
and produce vertical lines on the scanned
images. This occurs because the spaces
between frames vary slightly between films and
may cause the scan area to extend beyond the
image in the frame. If this occurs, place the
objective frame in the first position and scan
one frame at a time.
When 35 mm film is scanned without starting
up the driver software, the scanned image will
encompass slightly less than the entire image in
the frame.
13