Removing And Replacing The Processor Board Tray - Compaq ProLiant 2500 Installation Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-8 Overview of Installing ProLiant 2500 Server and Hardware Options
Removing and Replacing the Processor
Board Tray
The processor board tray holds the processor board and its components:
memory, switches, and connectors. To remove the processor board tray and
locate the processor board:
1.
2.
3.
CZR-007.EPS
Processor Board
Tray Ejector Lever
Figure 3-4. Removing the Processor Board Tray
4.
If the computer is on, turn it off and disconnect the power cord.
Disconnect any other external equipment connected to the processor
board tray. (Refer to figure below.)
CAUTION: If a security screw is installed in the side of the processor board
tray, remove the screw before opening the tray.
CAUTION: To prevent damage to internal wiring, contact your Authorized
Compaq Reseller before using the system board ejector lever.
Open the processor board tray.
System Board
Tray Ejector Lever
1
Remove the tray and turn the tray over to locate the processor board and
its components: processor, memory, switches, and connectors.
3
2