Page 1
2. Undo the two screws (6) on the camera mounting board (7). Slide the board backwards and lift it out. 3. Refer to the Axis Installation Guide provided with the Axis camera for instructions on camera hardware installation.
290B Outdoor housing 4. Attach the camera to the camera mounting board (7) using the screw attached to the board. You will find a screw hole at the bottom of the camera. Before tightening the screw, position the camera with the board inside the housing (with the lens to the front) and determine the camera’s correct position.
290B Outdoor housing Installing the housing Recommendation: Keep the housing closed when possible to prevent the build-up of dust and moisture inside the housing. This product should be installed by certified electrical technicians in compliance Important: with local laws and regulations. Warning: High voltage.
Page 4
290B Outdoor housing 1. Detach the bracket from the housing by unscrewing the positioning bolt (13). Use the large allen key (1) to do this. Continue until the swivel (11) (still attached to the housing) comes completely loose from the bracket arm (12). The positioning bolt (13) is held in the bracket arm (12) by a plastic washer inside.
AXIS 2420 using a Coaxial cable - attach an RG59 BNC plug to the coaxial cable. Once you have fitted the BNC plug to the cable connect it to the video output at the back of the camera.
Page 6
AXIS 2420 - plug the green power connector into the socket labelled I/O-A. AXIS 211A - replace the 4 pin green power connector coming from the 12V DC power supply with the 4 pin green terminal block supplied with the camera and connect the...
• Ensure that the lens setting is correct and make final adjustments if required (refer to Axis Installation Guide). • Ensure that the window is clean. Wipe it with a dry cloth if it is not. Do not use a damp or wet cloth! Ensure that no tools/loose parts are left in housing.
Specifications Weight Power requirements Operating temperature Approx. 6 lbs AXIS 290B Power adapter (included): -4F to 108F (-20°C to +42°C) (2,75 kg) Input voltage: 100-240 (50/60HZ) VAC Warning: The housing should not be exposed to many hours Input current Max 1.2A...