Table of Contents
Advertisement
Installation
Materials
Needed
• '/4" outer diameter flexible copper tubing
• Shut-off valve (requires a '/4" hole to be drilled into
water supply line before valve attachment)
• Adjustable
wrench
• '/_" hex nut driver
Note
• Add 8' to tubing
length needed to reach water
supply for creation of service loop.
1. Create service loop with copper
tubing
(minimum
2' diameter).
Avoid kinks in the copper tubing
when bending the service loop.
2. Remove plastic cap from water valve
inlet port.
3. Place brass nut (A) and
sleeve (B) on copper
tube end as illustrated.
(Do not use old sleeve.)
A
=_=*
@
4. Place end of copper tubing
into water
valve inlet port. Shape tubing slightly. Do
not kink - so that tubing feeds straight
into inlet port.
5. Slide brass nut over sleeve and screw nut
into inlet port. Tighten nut with wrench.
IMPORTANT:
Do not overtighten.
Cross
threading
may occur.
.
Pull on tubing to confirm connection
is
secure. Connect tubing
to frame with
water tubing
clamp (C) and turn on
water supply. Check for leaks and
correct if necessary. Continue to
observe the water supply connection
for two to three hours prior to moving
the refrigerator
to its permanent
location.
7. Monitor water connection
for 24 hours.
Correct leaks, if necessary.
Handle Installation
If not installed, the handle is located in the interior of the
fresh food section or attached to the back of your refrig-
erator. Remove and discard handle packaging
and tape.
Handle design varies from refrigerator
to refrigerator.
Please reference the appropriate
instructions
for your
model.
Front Mount
Handle
with Extensions
Materials
Needed
• Gloves to protect hands
• Phillips screwdriver
• Plastic door handle removal card (or '/_2"thick plastic
card), retain the card
Attach
Extensions to Handle:
1. Align handle and
extension as shown.
Place extension
in
handle opening.
Apply slight pressure
to both sides of the extension piece.
Slide extension until it stops on inside edge of
handle.
To Install:
1. The handles are to be oriented
as shown.
Align front mount door handle
clip with the door tabs.
Ensure the handle clips are
positioned
slightly above the
door tabs.
i
_ndle
Tab
/4. Rotate the handle so that the
handle is flat against the door.
Advertisement
Table of Contents
