Table of Contents
Advertisement
Troubleshooting
Ice and Water
Freezer door is not chose&
Verify' that freezer door is chose& Power is removed
No indicator lights
are lit on dispenser
control
_ce
or
water
are
not dispensed
when pads are
pressed
racemaker is not
producing
enough
ice or ice is
malformed
racemaker is not
producing
ice
Water filter
Refrigerator is not pHuggedin.
Fuse is Mown, or circuit breaker needs to
be reset.
Power outage has occurred.
Refrigerator is in Sabbath Mode (sdect
modds_)=
Freezer door is not chose&
Contrails are in Hockmode (sdect modds_).
Water tank is filling.
Ice maker has just been installed or a
Hargeamount of ice has been used.
Water filter is clogged or needs to be
changed.
Ice maker has just been installed or a
large amount of ice has been used.
Water pressure is too low.
Water filter is clogged or needs to be
changed.
Ice maker arm is up.
Household water supply is not reaching
water valve.
Copper tubing has kinks.
Water pressure is too low.
Check freezer temperature.
Ice bin is not installed properly.
Improper water valve was installed.
Water tiger needs to be replaced.
Filter indicator
sensor needs to be reset.
red
from the control when freezer door is opened.
Plug in refrigerator.
Replace any blown fuses.
Check circuit breakers for any tripped circuits.
Call local power company listing to report outage.
See Sabbath Mode page 17_
Verify' that freezer door is closed. Power is removed
from the control when freezer door is opened.
See Dispenser Lock page 17.
At initial use, there is an approximate one- to two-
minute delay in dispensing while the internal water
tank is filling.
Wait 24 hours for ice production to begin or for ice
maker to restock after emptied.
Change water filter (see page 18].
Wait 24 hours for ice production to begin or for ice
maker to restock after emptied.
Low water pressure can cause valve to leak.
Water pressure must be between 35 to 1O0 pounds
per square inch to function properly. A minimum
pressure of 35 pounds per square inch is
recommended for refrigerators with water filters.
Change water filter (see page 18].
Confirm ice maker arm is down. See Automatic Ice
Maker page 15.
See Connecting the Water Supply pages 4 and 5.
Turn off water supply and remove kinks.
If kinks cannot be removed, replace tubing.
Water pressure must be between 35 to 100 pounds
per square inch to function properly.
A minimum pressure of 35 pounds per square inch is
recommended for refrigerators with water filters.
See Temperature Contro_2pages 8 and 9 to adjust
controls. Freezer must be between 0° to 2° F (-18° to
-17 ° C) to produce ice.
See Ice Storage Bin page 15.
See Connecting the Water Supply pages 4 and 5.
Self-piercing and _,_"saddle valves cause low water
pressure and may clog the line over time. The
manafacturer is not responsible for property damage
dae to improper installation or water connection.
If filter is not available, replace with bypass filter.
See Water Ffl'terpage 18.
See Filter Status Indicator Light page 17_
continued...
31
Advertisement
Table of Contents
