Table of Contents
Advertisement
Toshiba DST-3000 High Definition Digital Receiver
VCR Setup
The VCR SETUP screen provides access to the
settings that will allow the DST-3000 receiver to
communicate the record and stop commands to your
VCR.
Brand
Using the
L
and
L
keys, search through the various
brands of VCRs that are supported. Related brands
that share the same control codes may be suggested.
You may want to experiment with these if you are
having difficulty finding a functioning code under
The VCR SETUP screen
your VCR's own brand name.
Code
L
More than one code may be assigned to your brand of VCR. Try each of the codes by using the
and
L
keys to step through each code. Alternate between this procedure and testing the code.
Test (Record/Stop)
The testing function allows you to verify that the specified code will control your VCR. To run
the test, the VCR control cable must be properly attached (see "Setting Up Your Satellite
Receiver" in Chapter 2), a recordable tape must be in the VCR, and the VCR must be turned on.
Use the buttons on the front panel of the DST-3000 receiver (instead of the remote control) when
testing the codes, because signals coming from the remote control at the same time as signals
coming from the VCR control cable could give unreliable test results.
Be sure to test both the Record and the Stop commands, which are necessary for successful taping
capability. If either Record or Stop fails to function, try other codes associated with your VCR
brand. If you are unsuccessful in the test process after trying all available codes, recheck your
VCR control cable connections and IR emitter placement.
Scheduler
Highlighting the Scheduler button on the MAIN
MENU screen and pressing the
key on the
SELECT
remote control will display the SCHEDULER screen
shown.
On the left are the buttons for Done and Video
explained immediately below:
Done
Highlighting the Done button on the screen and
The SCHEDULER screen
pressing the
key on the remote control causes an
SELECT
exit from the SCHEDULER screen and a return to the MAIN MENU screen.
Video
Highlighting the Video button on the screen and pressing the
key on the remote control
SELECT
will return you to the last program you were viewing.
Page 7-12
Advertisement
Table of Contents
