Hd Receiver And Standard Definition Tv Monitor - Toshiba DST-3000 Owner's Manual

HD Receiver and Standard Definition TV Monitor

Follow these steps indicated by the diagram on the next page:
1) Connect the satellite dish antenna and terrestrial antenna or cable service to the HD
receiver following the instructions in "HD Receiver and Satellite Dish Antenna with Ter-
restrial Antenna or Cable Service" on page 2–3.
2) Connect one set of standard audio/video cables (one yellow video connector, one white
left audio connector, and one red right audio connector) to the back of the HD receiver
using the connectors marked AUDIO L, R and VIDEO. Connect the other end of the
audio/video cable to the back of the TV monitor using the AUDIO and VIDEO inputs.
Optional: If your TV has an S-VIDEO input, then connect one end of an S-video cable
to the back of the HD receiver using the output marked S-VIDEO. Connect the other end
of the S-video cable to the back of the TV using the S-VIDEO input that matches the
previously used audio inputs. If you use an S-video cable, you will not need to use the
yellow video cable.
3) Optional: If the TV does not have AUDIO/VIDEO input connectors, then connect one
end of a coaxial RF cable to the OUT TO TV connector on the back of the HD receiver.
Connect the other end of the coaxial RF cable to the antenna input connector on the back
of the TV. Set the CH3/CH4 switch on the HD receiver to the channel not used in your
area. It is this channel you will select on your TV to view the HD receiver.
Note: When the HD receiver is in HD output mode or in standby (power LED
off), the RF signal received on the IN FROM ANT connector will pass
through to the OUT TO TV connector.
Page 2-8
Toshiba DST-3000 High Definition Digital Receiver