Front Panel Connections/Status Led; Rear Panel Connections - Directed Electronics 64602610 400.2 Owner's Manual

FRONT PANEL CONNECTIONS/STATUS LED

1. R R C C A A O O u u t t p p u u t t J J a a c c k k s s - These pass
through RCA jacks can be used to
send a signal to a second amplifier.
2. R R C C A A I I n n p p u u t t J J a a c c k k s s - Accepts line level
outputs from head units or signal
processors at voltages between
150mV and 8 volts.
FIGURE 1—AMPLIFIER CONNECTIONS 400.2 FRONT
1

REAR PANEL CONNECTIONS

1. S S p p e e a a k k e e r r O O u u t t T T e e r r m m i i n n a a l l s s - Connect
the speakers to these terminals.
(Refer to the Speaker Connection
section of this guide.)
2. R R e e m m o o t t e e T T u u r r n n O O n n - This terminal
turns on the amplifier when (+) 12
volt is applied to it. Connect it to
the remote turn on lead of the head
unit or signal source. If a (+) 12
volt remote turn lead is not avail-
able, a Remote Power Adapter
8
3. S S t t a a t t u u s s L L E E D D - Will light green to indi-
cate the amplifier is on and oper-
ating normally and will be off if the
amplifier shuts down due to short
circuit, DC offset, or overheating
detected by on-board protection
circuitry.
2
(P/N #55000) can be used to
supply a remote turn on signal. DO
NOT connect this terminal to
constant (+) 12 volt.
3. P P o o w w e e r r F F u u s s e e s s - These fuses protect
the amplifier against internal elec-
trical damage and are meant to
protect the amplifier only. All other
power connections should be fused
at the source.
3
© 2002 Directed Electronics, Inc