Parallel Synced Gain Connections/Settings - Directed Electronics 64601910 d2500.1 Owner's Manual

PARALLEL SYNCED GAIN CONNECTIONS/SETTINGS

1. I I n n p p u u t t S S i i g g n n a a l l - Connect these RCA
jacks as described in the Front Panel
Connection section of this guide.
2. S S l l a a v v e e / / M M a a s s t t e e r r S S w w i i t t c c h h
Set the slave/master switch
on the master amplifier to the
MASTER position.
Set the slave/master switch
on the slave amplifier to the SLAVE
position.
Setting the slave/master
switch on both amplifiers will auto-
matically set the I/O RCA jack
configuration according to each
amplifier's slave or master designa-
tion.
N N O O T T E E : : One master amplifier can control up to three slave
amplifiers in this combination. Multiple identical
master/slave combinations can be added to any
given system.
3. R R e e m m o o t t e e S S u u b b L L e e v v e e l l C C o o n n t t r r o o l l - Connect
the Remote Sub Level Control to the
master amplifier only. The master
amplifiers subwoofer gain is used to
set the overall gain for all synced
amplifiers, then the Remote Sub
Level Control can adjust the gain of
all synced amplifiers.
16
4. S S i i g g n n a a l l C C o o n n n n e e c c t t i i o o n n - Connect an RCA
cable between the SYNC OUT RCA
jack of the master amplifier and the
SLAVE IN RCA jack of the slave
amplifier as shown in Figure 5.
5. S S u u b b w w o o o o f f e e r r S S p p e e a a k k e e r r C C o o n n n n e e c c t t i i o o n n - In
this amplifier combination each
amplifiers must drive its own sepa-
rate subwoofer(s). Connect the
speaker terminals of each amplifier
to any combination of one or more
subwoofers that results in nominal
impedance between two and four
ohms. Make sure that each amplifier
sees the same speaker impedance.
© 2002 Directed Electronics, Inc