Alesis M-EQ 230 User Manual page 9

the same as simply raising the volume level. In this case, do the
following:
1 ) With the instrument playing, start by boosting 3 sliders
at a time until the offending frequency area is found. (If
the
Clip
2 ) Now, decrease the sliders until you are cutting the level
instead of boosting.
3 ) Experiment with the amount of decrease of the adjacent
sliders as in feedback control (see Figure 4B).
PLEASE NOTE:
The M-EQ 230 (and all other graphic Equalizers) will sound best when the
sliders show a gradual slope rather than a few wild boosts or cuts (See Figure
4A and 4B).
Since the M-EQ 230 can be used with any electric instrument or
microphone requiring tonal alteration, here are some generic
suggestions as to setup.
different due to the uniqueness of the instrument itself, the type of
music being played, the arrangement, and the touch of the player,
you must use your ears (and the chart below) to ultimately find the
correct settings.
FIGURE 5
KEY FREQUENCIES FOR INSTRUMENTS
INSTRUMENT
Bass Guitar
Bass Drum
Snare
Hi-Hat and Cymbals
Toms
Floor toms
Electric Guitar
Acoustic Guitar
Piano
Horns
LED should light, turn down the
Since each instrument will sound
Attack or pluck is increased at 700 or 1KHz; Bottom added at 60 or 80Hz;
string noise at 2.5KHz
Slap at 2.5KHz; Bottom at 60 or 80Hz
Fatness at 240Hz; Crispness at 1 to 2.5KHz; Bottom at 60 or 80Hz
Shimmer at 7.5 to 10KHz; Klang or gong sound at about 200Hz
Attack at 5KHz; Fullness at 240Hz
Attack at 5KHz; Fullness at 80 or 120Hz
Body at 240Hz; Clarity at 2.5KHz
Body at 240Hz; Carity at 2.5KHz; Bottom at 80 or 120Hz
Bass at 80 or 120Hz; Presence at 2.5 to 5KHz; Crispness at 10KHz;
Honky-tonk sound at 2.5KHz as bandwidth is narrowed; Resonance at
40 to 60Hz
Fullness at 120 or 240Hz; Shrill at 7.5 or 5KHz
control)
Input
KEY FREQUENCIES
9