Summary of Contents for Kenmore 7748 - 30 in. Gas Range
Page 1
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. if the information in this manual is not followed exactly, a fire or explosion result causing property damage,...
Page 2
important Notes to the Installer Read all instructions contained in these installation Never leave children alone or unattended instructions before installing range. in the area where an appliance is in use. As children grow, Removeall packing material from the oven compartments teach them the proper, safe use of all appliances.
Locate the Bracket Using the Template- (Bracket may Before Starting be located on either the left or right side of the range. Use Tools You Will Need the information below to locate the bracket if template is For leveling legs and Anti-Tip Bracket: not available).
Level and Position Range- Level range by adjusting the Connect range to the supply. (4) leveling legs with a wrench. Note: A minimum clearance NOTE: To prevent leaks use pipe joint sealant on all male of 1/8" is required between the bottom of the range and the (outside) pipe threads.
Page 5
the 1/2" flare union adapter with an adjustable wrench before tightening the gas supply fitting and/or appliance conduit (Refer to Fig. 4e). Installflare union adapter to external manual shut-off valve. Attach appliance conduit to flare union on shut-off valve. Make cure service shut-off valve on pressure regulator is in the "ON"...
Page 6
6. Assembly of the Surface Burner Heads, PLEASE READ CAREFULLY! For personal Burner Caps and Burner Grates: safety, this product must be properly grounded. Your range is shipped with the Burner Heads and Burner Grounding instructions Caps located in the correct locations. Packing material is The power cord of this appliance is equipped with a located between the Burner Heads and the cooktop.
Page 7
REMEMBER-- DO NOT ALLOW SPILLS, FOOD, Test to verify if "LOW" setting should be adjusted CLEANING AGENTS OR ANY OTHER MATERIAL Push in and turn control to LITE until burner ignites. ENTER THE GAS ORiFiCE HOLDER OPENING. Always Push in and quickly turn knob to LOWEST POSITION. keep the Burner Caps and Burner Heads in place whenever If burner goes out, reset control to OFF.
10. Air Shutter-Oven Burner Range 12. Make Sure is Level. Level the range by placing a level horizontally on an oven rack. Check diagonally from front to back, then level the range by either adjusting the leveling legs or by placing shims under the corners of the range as needed.