Table of Contents
Advertisement
PLEASE
READ CAREFULLY!
For personal
safety,
this product
must be properly
grounded.
Grounding
instructions
The power cord of this appliance is equipped with a
3-prong (grounding)
plug which mates with a standard
3-prong grounding
wall receptacle to minimize the possibility of
electric shock hazard from this appliance.
The customer should
have the wall receptacle and circuit checked by a qualified electrician
to make sure the receptacle is properly grounded and polarized.
Preferred
Not, Under
g Prong.
Power Supply
Grounding
Cord with
Type
3=Prong
Wall
Grounding
Receptacle
Plug
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THETHIRD(GROUND)
PRONG FROMTHE POWER CORD.
Where a standard two-prong wall receptacle is encountered,
it is
the personal responsibility
and obligation of the customer to have
it replaced with a properly grounded three-prong
wall receptacle.
Bridge Burner Head
I
6. Assembly
of the
Surface
Burner
Heads,
Burner
Caps and Burner
Grates:
Your range is shipped with the Burner Heads and Burner
Caps located in the correct locations. Packing material is
located between the Burner Heads and the cooktop.
a.
Remove any packing tape from cooktop. Remove all Burner
Caps & Burner Heads.
b.
Discard any packing material under the Burner Heads.
c.
Match the letter located under center of Burner Cap with letters
located inside the Burner Heads (See Figs. 1 & 2). NOTE: The
Bridge Burner Head and 3 Bridge Burner End Caps ARE NOT
MARKED with letters.
d.
Match the letter stamped on the cooktop (Bridge Skirt) with the
Burner Heads and Burner Caps (See Figs. 1 & 2). Each of the
Burner Heads MUST have a Burner Cap installed to insure
proper
ignition
and gas flame
size.
Note:
The Burner
Electrodes must be located properly in slots of each Burner
Head (See Fig. 2).
e.
CAREFULLY
align (DO NOT FORCE) the 2 Electrode holes
on the Bridge Burner Head over the 2 Bridge Burner
Electrodes located near center of the cooktop. After placing
the Bridge Burner Head on the cooktop, BE SURE that the
Bridge Burner Head lies evenly on Bridge Burner Skirt.
f.
Replace all 3 Bridge Burner Caps. These include 1 Bridge
Burner Center Cap (rectangular shaped) and the 2 Bridge
Burner End Caps (The Bridge Burner End Caps will fit at
either the front or rear Bridge Burner Head locations). Make
sure that the tabs located under the Bridge Burner Caps fall
into the slots located in the Bridge Burner Head (See black
arrows in Fig. 3) and that the Bridge Burner Caps lie flat
and evenly on top the Bridge Burner Head.
g.
Unpack Burner Grates. Position both End Burner Grates on
cooktop. Then place Center Burner Grate into position
between the end Burner Grates.
Burner
sizes
and locations
Example of Burner Assembly
(except Bridge Burner)
Fig. 3
2 Electrode
hole
locations
through
Bridge
Burner
Head
B=9.5k
A=5k
not
_- marked
18k
F = 17.2k
...........................................................................
F;oot ofoookto
Fig. 1
inclrOsdlet or hole
Fig. 4
for Simmer Burner Head
Burner
Head
Burner
Cap
Fig. 2
Hide quick links:
Advertisement
Table of Contents
