Complete The Installation - Whirlpool XHP1550WR Installation Instructions Manual

5.
attach the pedestal
Move the pedestal against the washer/dryer bottom. Slide the
pedestal's keyhole slots over the lower two partially installed
screws.
6.
secure the pedestal
Position the pedestal toward the front of the washer/dryer and
install the two remaining hex-head sheet metal screws. Do not
tighten completely.
7.
align sides of pedestal
Align the sides of the pedestal so that they are even with the
sides of the washer/dryer. Reach inside the pedestal opening
and securely tighten all four pedestal screws.
6
8.
Prepare pedestal feet
The pedestal arrives with the feet tight against the bottom of
the unit. Using a 1/4" hex head ratchet or open-end wrench,
lower the feet approximatey 1" (25 mm) away from the bottom
of the pedestal.
9.
stand the washer/dryer upright
Tip the washer/dryer back to its upright position. Remove any
remaining packaging material. Dispose of/recycle all packaging
material.

COMPLETE THE INSTALLATION

10.
move close to final location
Follow the installation instructions that came with your model
to finish installing or reinstalling your washer/dryer (i.e., hoses,
vents, etc.).
note: Be sure to remove the transport bolts from the back of
the washer.
1"
(25 mm)