Whirlpool XHP1550WR Installation Instructions Manual page 4

Installation of new washer/dryer
Confirm transport bolts are in place
If your washer/dryer is still in the packaging:
Washer/dryer still in packaging
note: Transport bolts are only in washers.
Dryer
Washer
Cut packaging as follows:
Washer: Cut plastic film along dotted cut line around the
base. Do not remove the packaging. Locate the transport
bolts on rear of washer. Transport bolts must remain in washer
while pedestal is installed. When laying the washer on its back,
hold the bottom cap down on the floor. Do not remove the
plastic film, corner posts, or top cap.
dryer: Cut carton around top and down corners along dotted
cut lines. Lay all four carton sides on floor. Discard carton top
and corner posts.
4