Whirlpool XHP1550WR Installation Instructions Manual page 7

11.
Check levelness of washer/dryer
Place level here
Place a level on top edges of washer/dryer, checking each
side and front. Rock washer/dryer back and forth to make sure
all four feet make solid contact with floor.
Not Level
If not level, adjust pedestal feet up or down, repeating as
necessary.
12.
adjust pedestal feet
Locate the 1/4" hex-head screws on the top of each pedestal
foot. Reach inside the pedestal and use a 1/4" hex-head
ratchet or open-end wrench to adjust the feet up or down
as needed, to level the washer/dryer.
note: Make sure all four pedestal feet are in solid contact
with the floor.
level
Not Level
13.
securely tighten jam nuts
When the washer/dryer is level, use a 9/16" open-end wrench
to securely tighten all four jam nuts against the pedestal.
ImPoRtant: The jam nuts must be tightened to avoid
vibration.
14.
Reassemble pedestal drawer
Drawer slide
Hex-head screw
Pull both drawer slides out and reassemble the drawer to the
drawer slides with the two hex-head screws.
15.
Place drawer divider
Remove the divider from the bag. Place the divider in the
drawer at the desired location. Close the drawer.
note: Use of the divider is optional.
7