Check The Status Of Projector - Sanyo PDG-DHT100L - DLP Projector - HD 1080p Owner's Manual

Check the status of projector

In the "Power & Status" page, you can control the projector power, and also you can
check the status of the projector as follows. To change the page, click on the page
number linked text.
Items Description
Lamp Mode ....................Displays 2 lamps or 4 lamps mode and lamp status as below icons with
Accumulated
Lamp-use Time ..............Displays the accumulated lamp use time in hour units (h) and displays each
Accumulated
Projector-use Time ..........Displays the accumulated projector use time in hour unit (h).
Power Status ..................Displays the status of the lamp.
Projector Condition* ........Displays the status of the projector's power.
Input Status ....................Displays the selected input.
Selection..........................Displays the selected input mode.
Signal Status ..................Displays the signal status of the selected input mode.
Inside temperature ..........Displays the internal temperature of the projector. The icons [A], [B], [C] on
The icons [A] , [B] and [C] represent the sensors located in the projector as follows:
[A]: Surrounding temperature of the projector*
[B]: Internal temperature of the projector
[C]: Internal temperature of the projector*
* 1 The indicated peripheral temperature of the projector is a little higher than actual surrounding tem-
perature.
* Sensor C icon may not indicated depending on the projector's model type.
2
Lamp1/Lamp2/Lamp3/Lamp4 order.
Yellow
....................Normal
Gray
....................Off
time with Lamp1/Lamp2/Lamp3/Lamp4 order.
* When occurring the internal power failure, The word "Power Failure" and error
information is displayed.
the page represent the thermal sensors*
perature at one of those sensors exceeds specified temperature, the appear-
ance of its icon changes to the following alert icon to let users know about
the abnormal temperature. Please check surrounding temperature of the pro-
jector, check for clogged air filters and check area surrounding the ventilation
fans.
1
2
Check the status of projector
Red
....................Lamp replacement required
Gray with X
....................Abnormality of the lamp
2 located in the projector. If the tem-
OWNER'S MANUAL
37
Network Board