I F The Scanner I S Not Properly Connected - Visioneer PAPERPORT ONETOUCH SCANNER Installation Manual

8 P P O
APER ORT NE
T S I
OUCH CANNER NSTALLATION
4. Click OK to close the dialog box.
That's it. Your OneTouch Scanner is ready to scan.
See "Scanning By Pressing the OneTouch Buttons" on page 12.
I S I
F THE CANNER S
If the scanner icon on the Windows taskbar has a red "X" through it as
shown in the figure, the scanner is not properly connected.
Check the following possible problems:
Is a cable loose or not plugged in securely? Inspect all cable
connections. Make sure all the cables are plugged in securely.
Is the scanner's power light on? If it isn't, plug the power adapter
into another electrical outlet.
Are you using an older computer that has 25-pin connectors for both
serial and parallel ports? You may have plugged the scanner cable
into a serial port instead of the parallel port. Remove the scanner
cable from the serial port and plug the cable into the parallel port.
Are other devices "daisy-chained" to the parallel port? If so, the
scanner must be the first one connected to the computer (with
the exception of a Zip drive which must be connected directly to
the computer and the scanner then connected to the drive).
Plug the scanner into the computer's parallel port first, then plug
the next device into the scanner.
Did you restart the computer after installing the software? If you
didn't restart the computer, it may not have loaded all of the
software files. Try restarting your computer.
Please see the Readme file on the CD for additional information that
may help you diagnose problems connecting the scanner.
G
UIDE
N P C
OT ROPERLY ONNECTED