Valet Mode; Panic Mode - Directed Electronics 440HP Owner's Manual

Directed electronics remote start alarm system owner's guide 440hp

Table of Contents

➜

valet mode

You can prevent your system from automatically activating the

Failsafe

Starter Kill and locking the doors by using Valet

This is very useful when washing the vehicle or having it serviced.

In Valet

Mode, the starter kill cannot be activated, even with the

transmitter, but all convenience functions (door locks, remote

start, etc.) will continue to work normally.

To enter or exit Valet

The status LED will light steadily if you are entering Valet

and will turn off if you are exiting Valet

➜

If you are threatened in or near your vehicle, you can attract

attention by triggering the system with your transmitter. Just

press

the horn will honk and the parking lights will flash for 30

seconds. To stop Panic Mode at any time, press

mitter again.

note: In order for Panic Mode to be effective, the vehicle's

horn (or optional siren) as well as the vehicle's parking

lights must be connected.

Mode:

1. Turn the ignition on.

2. Turn the ignition off.

3. Press and release the Valet®

switch within 10 seconds.

for two seconds to enter Panic Mode. In Panic Mode,

DRW-35

Mode.

on the trans-

Mode.

Mode

Table of Contents