Ager; Remote Control Setting; Remote Transmitter Programming Table - AstroStart RSS-5224 User Manual

REMOTE CONTROL SETTING

Certain functions on the remote may be set to your convinience.
To access the remote control programming mode, press the
seconds.
The remote beeps once to endicate entering programming mode.
R
EMOTE TRANSMITTER PROGRAMMING TABLE
P
ARAMETERS
Keyboard Un/Lock
Mute
Status confirmations
Auxiliairy sensor icon
Back-light
Number of vehicle
L
EGEND
PAGER
The system is equipped with a function called 'Pager'. The purpose of this function is to send a general call asking those
who carry them to get to the vehicle or to perform a task previously established.
Paging
To send a general call, the user must press the 'Valet' switch and hold it for 3 seconds while engine is stopped and key is
not in the ignition, or while engine is remote started (see 'Valet Mode' on page 16)(The valet switch is a small push button
hided under the dash board).
Parking lights on the vehicle blink once to confirm the call was sent.
All remote controls (maximum: 4) located within the radio frequency range of the vehicle will begin to chirp. To silence the
remote control, press any button.
8
S
ETTINGS
Lock
Unlock
Disabled
Enabled
Enabled
Disabled
Trunk
Motion sensor
Glass breakage sensor
Tilt sensor
Ultrasonic sensor
Upon "Status" command
Upon any command
Never
1 – 4 (Default setting : 2)
: DISPLAYED ICON (BLACK) :
button located on the back of the remote and hold it for 5
B
UTTONS
MASKED ICON (GRAY) :
D / R
ISPLAY EMARKS
/ 1
BEEP
/ 2
BEEPS
/ 1
BEEP
/ 2
BEEPS
/ 1
BEEP
/ 2
BEEPS
T
HE DISPLAY LIGHTS
3
FOR SECONDS
-
BACK LIGHT SHUTS OFF
1 2 3 4
DEFAULT SETTING
1
BEEP
2
BEEPS
3
BEEPS
4
BEEPS
5
BEEPS
-
UP