Panamax MIW-5RCA Installation Instructions

Panamax MIW-Modules Installation Instructions
STEP 1:
Once the Max In-Wall AC Base Unit is installed (see the instructions that come with the base unit), connect the signal wires to
the module. Be sure to follow the appropriate color-coding or pin-out diagram. In-wall connections depend upon the module
and type of signal-lines being protected. Connection types may include:
• Wiring pigtails with color-coded BNC connectors for Audio/Video
• F Connectors for antenna, cable or Satellite TV lines
• 3.5mm stereo jacks for IR repeaters, 12 Volt triggers or L/R audio with common ground
• RJ-11 / RJ-45 jacks for telephone or network lines
• Screw-terminals for RS232 lines
Note: Protection circuits and their operational characteristics (bandwidth/frequency range, clamping voltages, attenuation, etc.)
are optimized for the intended application. Satellite TV circuits and antenna/cable TV circuits are different and cannot be
interchanged.
STEP 2:
Carefully feed the signal wires through the base unit as you insert the module into the opening.
The module may be installed with either end up, since there are two rows of retention dimples in the base unit. Depress the
spring balls on the module as they reach the face of the base unit (this will help the module slide into the opening).
The module can be installed to three depths; flush with the faceplate, half-depth or full-depth. The depth of installation just
depends on how you need the cables to dress.
REMOVAL
STEP 3:
TOOL
Connect cables (not included) to the equipment.
To remove a module, simply insert the included removal tool into the raised holes on the module face and pull.
MIW-5RCA
5 RCA
CONNECTORS
MIW-VGA
PINOUT DIAGRAM
1690 Corporate Circle, Petaluma, CA 94954 • Fax 707-283-5901 • www.panamax.com
MIW-VGA
MIW-SVIDEO
SPRING
BALL
RAISED
HOLES
MIW-SVIDEO
PIN CONNECTOR
DIAGRAM
2
1
1 - Yellow Shield
2 - Yellow Center
3 - White Center
4 - White Shield
• MIW-5RCA • MIW-VGA • MIW-SVIDEO
MIW-DATA
SVIDEO
MIW-DATA
TERMINAL BLOCK HEADER
-
1
2
3
4
3
5
6
7
4
8
MIW-DATA
- INWALL
RJ-45 JACK
1
2
3
4
5
6
7
8
• MIW-DATA
RS232
ETHERNET
RS232
- INWALL DIAGRAM
RJ-45 JACK
1
2
3
4
5
6
7
8
ETHERNET
DIAGRAM
RJ-45 JACK
1
2
3
4
5
6
7
8
INS0733 REV. D 1/05