Juniper JUNOSE 11.1.0 - REV 4-29-2010 Manual page 32

JUNOSe 11.1.0 Release Notes
24
Known Behavior
Deprecated Command
ip mirror
ip policy local-input
[ no ] ipsec isakmp-policy rule
ipv6 policy local-input
j1
license l2tp-session
lineCoding
log
log severity debug
dhcpLocalProtocolDecode
loopback
loopback remote { remote line fdl
ansi | remote line fdl bellcore |
remote line inband remote payload
[ fdl ] [ ansi ] }
mark
mark-de
mark-exp
mark-user-priority
mpls ldp discovery
transport-address
mpls topology-driven-lsp
ip-interfaces
[ no ] next-hop
[ no ] next-interface
Command Mode Preferred Command
Global Configuration ip policy secure-input and
ip policy secure-output; for
E120 and E320 routers, you
must use these commands
because the ip mirror
command has been
removed from the CLI for
those routers.
Interface Configuration, None
Profile Configuration
Global Configuration [ no ] ipsec ike-policy-rule
Interface Configuration, None
Profile Configuration
Controller Configuration
Global Configuration None
Controller Configuration
Policy List Configuration log in Classifier Group
Configuration mode
Global Configuration log severity debug
dhcpCapture
Domain Map Configuration local-interface
Still available in Controller
Configuration and Interface
Configuration modes
Controller Configuration
Policy List Configuration mark in Classifier Group
Configuration mode
Policy List Configuration mark-de in Classifier Group
Configuration mode
Policy List Configuration mark-exp in Classifier Group
Configuration mode
Policy List Configuration mark-user-priority in
Classifier Group
Configuration mode
Interface Configuration
in Interface Configuration
mode. Now available in
Global Configuration mode.
Global Configuration ldp ip-forwarding
Policy List Configuration forward next-hop in
Classifier Group
Configuration mode
Policy List Configuration forward interface in
Classifier Group
Configuration mode
This command has no effect