Flash; Gre; Hardware - Juniper JUNOSE 10.3.1 - RELEASE NOTES 3-19-2010 Release Note

JUNOSe 10.3.1 Release Notes

Flash

GRE

Hardware

20
Known Behavior
Primary/Secondary link signal detected
Primary/Secondary link signal not detected
Flash cards manufactured by Wintec are present on some currently deployed
routers. When you upgrade the JUNOSe Software on such routers, the firmware
on the flash card controller is automatically updated during diagnostics. During
this reboot, the software runs an integrity check on the file system to verify that
the firmware update did not corrupt the contents of the flash card. This
integrity check is an expected side effect of the enhanced firmware available in
this release. The integrity check does not indicate a problem with the flash card
or its contents.
When you shut down the only outgoing IP interface to the IP destinations of
GRE/IP tunnels, the tunnels remain in the up state rather than transitioning to
down. As a consequence, all IP routes that use these tunnels as next hops also
remain in the routing table.
SRP modules with only 1 GB of memory do not work reliably in ERX7xx and
ERX14xx routers running JUNOSe Release 8.1.0 or higher, and may experience
system resets due to an out of memory condition. However, the ERX310 router
still supports 1 GB of memory in the SRP-SE10 module.
Work-around: Upgrade your SRP module memory to 2 GB for all ERX7xx and
ERX14xx routers running JUNOSe Release 8.1.0 or higher.
Do not include a not protocol clause in any classifier control list for policies
attached to an interface on an ES2 10G Uplink LM. The not protocol
functionality is not available for this module.
The ES2 10G LM and the ES2 10G Uplink LM do not support VLAN statistics in
the current release.
PCMCIA NVS Card Caution
Before you insert or remove PCMCIA NVS (flash) cards from a running
CAUTION:
router, we strongly recommend that you halt the SRP module or shut down the
router. Failure to do this can result in file corruption in one or both cards.
The 4XOC3 APS MULTIMODE and 4XOC3 APS SINGLE MODE I/O modules are
incompatible with the following versions of the OCx/STMx ATM and OCx/STMx
POS line modules:
OCx/STMx ATM line modules with assembly numbers 350-00039-xx,
350-80039-xx, and 350-90039-xx
OCx/STMx POS line modules with assembly number 350-10039-xx