Replacing A Jcs1200 Alarm Panel Module Or Module Filler; Removing A Jcs1200 Alarm Panel Module Or Module Filler; Installing A Jcs1200 Alarm Panel Module Or Module Filler; Figure 37: Removing And Installing A Jcs1200 Alarm Panel Module - Juniper JCS1200 Hardware Manual

JCS1200 Control System Hardware Guide

Replacing a JCS1200 Alarm Panel Module or Module Filler

Removing a JCS1200 Alarm Panel Module or Module Filler

Installing a JCS1200 Alarm Panel Module or Module Filler

100
Removing a JCS1200 Alarm Panel Module or Module Filler on page 100
Installing a JCS1200 Alarm Panel Module or Module Filler on page 100
Figure 37 on page 100 shows how to remove and install an alarm panel module.

Figure 37: Removing and Installing a JCS1200 Alarm Panel Module

To remove an alarm panel module or module filler (see Figure 37 on page 100):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Pull the release handle to the open position. The module moves out of the bay
2.
approximately 0.25 in. (0.6 cm).
Slide the alarm panel module out of the bay.
3.
Figure 38 on page 101 shows how to remove and install an alarm panel module.
Copyright © 2010, Juniper Networks, Inc.