Juniper JUNOS 10.1 - RELEASE NOTES 5-13-2010 Release Note page 162

JUNOS 10.1 Software Release Notes
Management and Administration
Network Address Translation (NAT)
Power over Ethernet
SNMP
USB Modem
Virtual LANs (VLANs)
162
Issues in JUNOS Release 10.1 for SRX Series Services Gateways and J Series Services Routers
On SRX5600 and SRX5800 devices, the simple filter did not work after reboot
of the new primary node. [PR/486181: This issue has been resolved.]
On SRX210 and SRX240 devices, source NAT using interface IP address on the
interface was not working. Traffic was not forwarded because of NAT
pp0
translation failure through this interface. [PR/479256: This issue has been
resolved.]
On SRX210 and SRX240 devices, the output for the
command showed the telemetry data in chronological order rather than the
preferred reverse-chronological order (most recent data first). [PR/429033: This
issue has been resolved.]
On SRX3400, SRX3600, SRX5600, and SRX5800 devices, the value for the
jnxBoxDescr.0 MIB object was incorrectly displayed as SRX 3400 instead of
SRX3400. Note that there was no blank space between SRX and model number.
(3400/3600). [PR/490296: This issue has been resolved.]
On SRX210 Services Gateways with Integrated Convergence Services, when you
had USB modem configurations and you removed the USB modem from USB
port 1, the device rebooted. [PR/491777: This issue has been resolved.]
On SRX650 devices,
customer-vlans
same VLAN. [PR/476999: This issue has been resolved.]
On SRX5600 and SRX5800 devices, in Layer 2 mode the first packet was used
for MAC learning, and it wasl not flooded, so the first packet was dropped when
the MAC address was not available in the MAC table. [PR/486980: This issue has
been resolved.]
On SRX5600 and SRX5800 devices, IS-IS adjacency was not formed on the
VLAN-tagged reth interface.[PR/488899: This issue has been resolved.]
show poe telemetries
and did not work together for the
vlan-push