Edirol FA-66 Owner's Manual page 15

16.
AC adaptor jack
Connect the included AC adaptor to this jack.
* Never use any AC adaptor other than the supplied unit; doing so may cause
malfunction.
17.
FireWire (IEEE 1394) connectors
Use a FireWire (IEEE 1394) cable to connect these to your computer.
We recommend that you use a 6-pin cable to connect the FA-66 to your computer,
and a 4-pin cable to connect the FA-66 to any peripheral device you may be using.
fig.6-pin
• 6-pin connector
If the IEEE 1394 connector (FireWire connector, iLink connector, DV connector)
of your computer is a 6-pin type, use the included 6-pin ↔ 6-pin cable.
The FA-66 will be able to operate on bus power. Normally you should use this
method of connection.
If the IEEE 1394 connector (FireWire connector, iLink connector, DV connector) of
your computer is a 4-pin type, use the included 6-pin ↔ 4-pin cable. However, in
this case, the FA-66 will not operate on bus power.
fig.4-pin
• 4-pin connector
Normally, the 4-pin connector is used when connecting the FA-66 to a peripheral
device.
18.
Sample rate select switch
This specifies the sampling frequency at which audio data will be recorded and
played back. In order to get this setting to take effect, you must exit all of your
software, then cycle the power to the FA-66 (switch it off, then back on again).
* If you are using Macintosh and want to change the sampling frequency, you must
first power down the FA-66. Then, access the Mac OS System Preferences -
Sound, and verify that EDIROL FA-66 has disappeared from the Input and
Output panes. Then, power up the FA-66 again. For information on how to display
the Mac OS System Preferences - Sound, refer to "Audio settings" (p. 19).
You must set the sample rate select switch to match the sampling frequency
selected in the software you are using. If you use external synchronization mode
(i.e., the DIGITAL IN switch turned on), the external device's sampling frequency
must also be the same.
[ Limitations when using the FA-66 at 192 kHz ]
• You will not be able to use the digital input connector or digital output
connector.
Front and rear panel
15