Table of Contents
Advertisement
Information you will need about your DSL-502T ADSL Router:
Username
Password
LAN IP addresses for
the DSL-502T
LAN Subnet Mask for
the DSL-502T
Information you will need about your LAN or computer:
Ethernet NIC
DHCP Client status
It is recommended that your collect and record this information here, or in some other secure
place, in case you have to re-configure your ADSL connection in the future.
Once you have the above information, you are ready to setup and configure your DSL-502T ADSL
Router.
DSL-502T ADSL Router User's Guide
This is the Username needed access the Router's
management interface. When you attempt to connect
to the device through a web browser you will be
prompted to enter this Username. The default
Username for the Router is admin. The user cannot
change this.
This is the Password you will be prompted to enter
when you access the Router's management interface.
The default Password is admin. The user may change
this.
This is the IP address you will enter into the Address
field of your web browser to access the Router's
configuration graphical user interface (GUI) using a
web browser. The default IP address is 10.1.1.1 and
it is referred to as the "Management IP" address in
this User's Manual. This may be changed to suit any
IP address scheme the user desires. This address will
be the base IP address used for DHCP service on the
LAN when DHCP is enabled.
This is the subnet mask used by the DSL-502T, and
will be used throughout your LAN. The default subnet
mask is 255.0.0.0. This can be changed later.
If your computer has an Ethernet NIC, you can
connect the DSL-502T to this Ethernet port using an
Ethernet cable. You can also use the Ethernet ports
on the DSL-502T to connect to other computer or
Ethernet devices.
Your DSL-502T ADSL Router is configured, by
default, to be a DHCP server. This means that it can
assign an IP address, subnet mask, and a default
gateway address to computers on your LAN. The
default range of IP addresses the DSL-502T will
assign are from 10.1.1.2 to 10.1.1.254. Your
computer (or computers) needs to be configured to
Obtain an IP address automatically (that is,
they need to be configured as DHCP clients.)
viii
Record info here
Record info here
Advertisement
Table of Contents
