Rear Panels - NETGEAR GSM5212P Hardware Installation Manual

Table 1. LED Descriptions (Continued)
LED
PoE
Link/ACT
(RJ45 port)
SPD (RJ45 port)
PoE-PD
SPD/Link/ACT
(SFP port)

Rear Panels

The rear panels have a console port, a redundant power supply connector (only for
GSM7212F, GSM7212P, and GSM7224P), and a standard AC power receptacle for the
supplied power cord.
NETGEAR Managed Switch
Description
OFF: No PoE powered device (PD) connected
Solid Green:The PoE powered device (PD) is connected and the port is supplying
power successfully
Solid Yellow: Indicates one of the following failures resulted in stopping power to
that port:
- Short circuit on PoE power circuit
- PoE power demand exceeds power available
- PoE current exceeds PD's classification
- Out of proper voltage (44 ~ 57 VDC for af, 50~57 VDC for at)
OFF: No link is established on the port
Solid Green: A valid link is established on the port
Blinking Green: Packets transmission or reception is occurring on the port
Note: On the GSM7212F, if a combo port media changes to fiber, the copper port
LED will change to OFF status.
OFF: No link is established on the port
Solid Green: A valid 1000Mbps link is established on the port
Solid Yellow: A valid 10/100Mbps link is established on the por.
Note: On the GSM7212F, if a combo port media changes to fiber, the copper port
LED will change to OFF status
OFF: No PSE is connected or connected but has failed
Solid Green: The PSE is connected and get 30W power from PSE successfully
Solid Yellow: The PSE is connected and get 15.4W power from PSE successfully
Note: only for GSM5212P port 1 and 2
Off: No SFP/SFP+ module link is established on the port
Solid green: A valid 1000Mbps SFP+ module link is established on the port
Blinking green: The port is transmitting or receiving packets at 1000Mbps
Solid yellow: A valid 100Mbps SFP module link is established on the port
Blinking yellow: Packet transmission or reception is occurring on the port at
100Mbps
Note:If combo port media change to Copper, the SFP port LED will change to OFF
status.
Introduction
7