NETGEAR GSM5212P Hardware Installation Manual page 6

Table 1. LED Descriptions
LED Description
Power Solid green: Internal power supply operating normally and supplying power to the
switch
Solid yellow: The system is in boot-up stage
Blinking yellow: Power module is present but has failed
Off: Power is disconnected.
Fan Solid green: The fan is operating normally
Solid yellow: The fan has failed
Off: No fan is detected
RPS Solid Green: RPS connected (Using internal power supply's power)
Solid Yellow: The internal power supply has failed and the RPS is providing power
to switch.
Blinking Yellow: RPS is present but RPS has failed
Off: RPS Disconnected
Note: only for GSM7212F,GSM7212P,GSM7224P
PD Solid Green: PD port 1 is connected to PSE getting 802.3at specified power
Blinking Green: PD port 1 is connected to PSE getting 802.3af specified power
Off: PD port 1 is not connected to PSE
Note: only for GSM5212P
Max PoE Solid Yellow: Indicates less than 7W of PoE power is available
Blinking Yellow: Indicates the PoE MAX LED was active in the previous two
minutes
Off: There is at least 7W of PoE power available for another device
SPD/Link/ACT OFF: No link is established on the port
(RJ45 port)
Solid Green: A valid 1000Mbps link is established on the port
Blinking Green: Packets transmission or reception is occurring on the port at
1000Mbps
Solid Yellow: A valid 10/100Mbps link is established on the port
Blinking Yellow: Packets transmission or reception is occurring on the port at
10/100Mbps
Note: If combo port media change to fiber, the Ethernet LED will change to OFF
status
NETGEAR Managed Switch
Introduction
6