Kurzweil PC2KBD Musician's Manual page 113

Exit Save
Affects what happens when you exit an editor without saving. If the value if Never (the default),
the PC2 wonÕt prompt you to save your edits when you leave an editor (by pressing one of the
mode-selection buttons). In this case, the mode-selection button ßashes, prompting you to select
a bank (or press the same button again to enter that mode on the last program or setup you were
using in that mode).
If the value is Ask, leaving an editor without saving causes the PC2 to ask you if you want to
save your edits. You can press Yes or No as desired, or you can press a mode-selection button to
cancel your edits and return to a performance mode.
Drum Remap
Determines the layout of the timbres in drum programs. There are three possible values:
Default value. No remapping of drum timbres.
Normal
Assigns many timbres to different note numbers.
PC2ReMap
Remaps drum timbres according to the General MIDI layout.
GMReMap
KB3 MIDI Chan
SpeciÞes which channel can play KB3 programs (because they have special processing
requirements, KB3 programs are available on only one channel at a time). If you try to assign a
KB3 program to a channel thatÕs not the KB3 channel, the program change wonÕt take effect.
Tuning
You can tune the PC2 up or down one semitone, in one-cent increments. This can be useful if
you are playing along with a recording, or playing with other acoustic instruments that canÕt be
easily retuned. The default value is 0 cents.
Receive Transposition (Recv Trans)
This allows you to transpose the instrument globally, for all MIDI channels. (Using the
Transpose function in the zone parameters affects only individual zones in a setup, or if changed
in Internal Voices mode, affects any program you play on the keyboard, but not any information
coming in the MIDI In port.) The default value is 0 ST.
Bank-Select Controller (Bank Sel Ctl)
Determines how the PC2 responds to bank-select messages received at the MIDI In port. There
are four possible values:
Uses only MIDI Controller 0 as a bank-select command.
0
Uses only MIDI Controller 32 as a bank-select command.
32
Default value. Uses MIDI Controller 0 and 32 as a single combined bank-select
0/32
command, enabling selection of banks numbered from 0 to 16,383.
Responds to either MIDI Controller 0 or 32 as separate bank-select commands.
0or32
Descriptions of Parameters
System Parameters
5-33