Table of Contents
Advertisement
5. The PC displays a dialog informing you that Windows did not locate a driver for the SCSI
device. Click Finish to proceed without installing a driver.
6. Repeat Steps 4 and 5 seven times—once for each of the K2600's remaining SCSI Logical
Units. When you finish the last dialog, Windows finishes booting up.
7. Start the Device Manager (in the Start menu, select Settings, then Control Panels).
8. Select the System icon in the Control Panels window.
9. Select the Device Manager tab in the System Properties window.
10. Click the icon for Other Devices. You'll see the eight entries for the K2600. Note the
exclamation marks, indicating problems with the corresponding device drivers.
11. Double-click on one of the entries. This opens the Properties window for that entry.
12. Click the Drivers tab. The status for this entry indicates that the driver isn't working
properly, and that the driver files either are not required or haven't been loaded.
13. Click Update Driver. This opens the Update Device Driver Wizard, which asks whether
Windows should search for the driver.
14. Select the option No, select driver from list, then click Next. A list of driver types appears.
The default is Other devices.
15. Click Next to accept the default. A list of devices appears. The default is Unsupported
device.
16. Click Finish. This "installs" the driver and returns to the Properties window for the
current entry.
17. Click Close, which returns you to the Device Manager.
18. Repeat Steps 11 through 17 for the remaining entries.
19. Close the Device Manager and Control Panels window.
There's a page on our website where you can find more information about including a K2600
and a PC in a SCSI chain:
http://www.kurzweilmusicsystems.com/html/scsi_help.html
If a Partition is Inaccessible
On the PC
You're not likely to have problems addressing K2600 partitions from your PC, especially if you
created those partitions on the K2600 itself. If you can't mount a partition on your PC, try
reformatting the partition, using the K2600. If that doesn't work, do a hard format, then format
and partition the disk again.
On the Mac
System 8.5 or later—when used with the File Exchange extension—supports DOS partitions, so
you should be able to view partitions as file icons. If they aren't visible, try reformatting the
partitions using the K2600
Disk Partitioning
Working With Partitions
3-7
Advertisement
Table of Contents
