Replace Drive Belt - Bissell PowerForce 47M6 Series User Manual

M
aintenance and care

Replace drive belt

Use only BISSELL Style 10 replacement belts in
your BISSELL PowerForce Bagless.
1. Unplug cleaner from electrical outlet.
2. With rotating floor brush removed from vacuum
cleaner (Steps 1-4 of "Check rotating floor brush
and drive belt"), grasp old drive belt and remove
from motor pulley. Discard old drive belt.
3. Place new drive belt over motor pulley and
stretch other end over rotating floor brush in
the space between the bristles.
4. Place ends of rotating floor brush down into
slots on sides as shown.
5. Turn rotating floor brush by hand several times
in direction of motor pulley. If properly installed,
drive belt will center itself on rotating brush.
6. Reposition brush cover and replace four
screws. Make sure end of brush cover is
snapped into place.
w w w . b i s s e l l . c o m
ug110_4052_47M6_808.indd 11 ug110_4052_47M6_808.indd 11
Brush
Cover
11
8/12/08 1:34:34 PM 8/12/08 1:34:34 PM