Please Do Not Return This Product To The Store - Bissell PowerForce 47M6 Series User Manual

T
roubleshooting
Vacuum cleaner won't pick up dirt (continued)
Possible causes
5. Broken or worn drive belt
6. Rotating floor brush bristles worn
7. Rotating floor brush jammed
8. Clog in vacuum
9. Dirt container full
10. Dirt container not installed properly
11. Filters are dirty
Primary separator
12.
Tools won't pick up dirt
Possible causes
1. Crack or hole in hose
2. Vacuum hose, wand or tools clogged
3. Dirt container full
4. Dirt container or upper tank not installed properly
5. Filters are dirty
6. Primary separator missing or installed incorrectly
Vacuum cleaner difficult to push
Possible causes
1. Incorrect height adjustment
2. Rotating floor brush not rotating
Visible dirt escaping from cleaner
Possible causes
1. Dirt container full
2. Filters missing or installed incorrectly
3. Dirt container installed incorrectly
4. Filter cup installed incorrectly
Other maintenance or service not included in the manual should be performed by an
Thank you for selecting a BISSELL product.

Please do not return this product to the store.

w w w . b i s s e l l . c o m
ug110_4052_47M6_808.indd 13 ug110_4052_47M6_808.indd 13
missing or installed incorrectly
authorized service representative.
Remedies
5. Replace drive belt, see page 11
6. Replace brush
7. Remove brush and clean debris from brush ends
8. Follow instructions for clearing
clogs on page 12
9. Empty dirt container
10. Position correctly and lock in place
11. Check and clean inner and outer circular
filters, pre-motor and post-motor filters
12. Check for a clog in the tube in the center of the
dirt container, clear and properly install
primary separator
Remedies
1. Check hose and replace if needed
2. Follow instructions for clearing clogs on
page 12
3. Empty dirt container
4. Position correctly and lock in place
5. Check and clean inner and outer circular
filters, pre-motor and post-motor filters
6. Check for a clog in the tube in the center of the
dirt container, clear and properly install
primary separator
Remedies
1. Adjust powerfoot to correct height setting
2. Check drive belt and brush
Remedies
1. Empty dirt container
2. Check inner and outer circular filter and
post-motor filter for correct installation
3. Position correctly and lock into place
4. Remove dirt container and make sure filter
cup is fully attached
8/12/08 1:34:36 PM 8/12/08 1:34:36 PM
13