Dimension One Spas Aurora HP Specifications page 2

2003 Aurora HP Specifications
Caution:
Due to manufacturing tolerances there could be some minor differences between the actual spa and the
drawing abov e. If sit e planni ng is cri tical t o such tol erances, be sure to measure your act ual spa.
Note:
1. Subject to change without notice.
2. Engineering specs may differ slightly from brochure.
3. For E-Z Lifter installation allow 18" clearance on the backside of the spa.
4. Alternative cabinets may add significant weight. Ask your dealer f or exact detail s.
5. This is the approximate location for drilling a hole if you must bring the power
line in throu gh the bottom of the spa. Be caref ul not to punct ure
a plumbing li ne inside the equipm ent compar tment (drill from the inside Compartment ou t)
Doc-538 Rev-C Rev Date: 3/03/03
2003 Aurora HP , Architectural Specification
Top View of Spa
THIS 3 FOOT SQUARE AREA,
ON BOTTOM OF SPA, TO BE
SUPPORTED CONSISTENT WITH
THE EDGES OF SPA BASE.
Specification, 2003, Aurora HP
Dimension One Spas
Page 2 of 5