Dimension One Spas 2000 Model Owner's Manual page 31

29
2000 Owner's Manual
FILTER CYCLE START TIME
After setting the time-of-day, the top line of the LCD will read "SET
FILTER CYCLE TIME". Push the UP or DOWN pads in the same man-
ner as setting the clock to select the time you want your filter cycle to
start. When your desired filter cycle start time is set in the LCD display,
push the PROGRAM pad to continue. The pre-set factory default is
12:00 p.m. to 1:00 p.m. repeating every 12 hours unless the number of
filter cycles per day has been changed.
NOTE: Keep in mind that you will be later prompted to set the filter
cycle duration and the number of filter cycles. Be sure to keep this in
mind when programming your filter cycle start time.
During a filter cycle, the bottom left of the LCD will read "SPA FILTER-
ING". During the filter cycle, JETS 1 will activate, the first 5 minutes at
high speed and the remainder of the filter cycle time at low speed. JETS
2 will also activate for 1 minute on high speed and then turn off.
FILTER CYCLE DURATION
After setting the filter cycle start time, the top line of the LCD will read
"SET CYCLE DURATION". Push the UP or DOWN pads to toggle
between 60, 90, 120, 150 and 180 minutes. The first 5 minutes of the
filter cycle will be at high speed and the remaining time at low speed.
When your desired filter cycle length appears in the LCD, push the
PROGRAM pad to select it. The pre-set factory default is 60 minutes.
NUMBER OF FILTER CYCLES
After setting the length of the filter cycle, you will be prompted to set
the number of filter cycles. The top line of the LCD will read "SET #
OF CYCLES". Push the UP or DOWN pad to toggle from 1 to 2 to 3 to
4 cycles per day. When your desired number of cycles appears on the
LCD push the PROGRAM pad to select it. The pre-set factory default
is 2 cycles per day.
CAUTION: Long and/or numerous filter cycles could cause overheat-
ing of the spa - especially in hot climates.