Removing An Expansion Module - Cisco WS-X6148-GE-TX - Switch Hardware Installation Manual

Chapter 2 Installing the Cisco UCS 6100 Series Fabric Interconnect
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m

Removing an Expansion Module

To remove an expansion module from the chassis, follow these steps:
Ensure that the system (earth) ground connection has been made. For ground connection instructions,
Step 1
see the
Step 2 Disconnect any network interface cables attached to the module.
Loosen the captive screw on the module.
Step 3
Remove the module from the chassis by grasping the handle on the right side of the module and sliding
Step 4
the module part of the way out of the slot. Place your other hand under the module to support the weight
of it. Do not touch the module circuitry. See
Figure 2-12
OL-20036-02
"Grounding the System" section on page
Removing an Expansion Module From the Cisco UCS 6120XP
2-11.
Figure 2-12 or
Cisco UCS 6100 Series Fabric Interconnect Hardware Installation Guide
Replacing or Installing Components
Figure 2-13.
2-23