[5] UNPACKING AND
INSTALLATION
1. Installing conditions
1) Copier installation
Do not install your copier in areas that are:
•
damp, humid, or very dusty
•
exposed to direct sunlight
•
poorly ventilated
•
subject to extreme temperature or humidity changes, e.g., near an
air conditioner or heater.
•
Be sure to allow the required space around the machine for servic-
ing and proper ventilation.
2) Power source
•
Use an exclusive-use power outlet. If the power plug of this
machine is inserted into a power outlet commonly used with other
illumination units, flickers of the lamp may be result. Use a power
outlet which is not used commonly with any illumination units.
•
Avoid complex wiring.
3) Grounding wire connection.
•
To avoid danger, be sure to connect a grounding wire. If no
grounding wire is connected and a leakage occurs, a fire or an
electric shock may be result.
2. Removal of protective material and
fixing screw
1) Remove all tapes and protective material.
•
Remove all tapes, then open the document cover and remove
the protective material of sheet shape
2) Remove the fixing screw.
•
Use a coin to remove the fixing screw.
•
The fixing screw is required when transporting the machine.
Keep it in the tray. (Refer to the later description.)
4" (10 cm)
5 – 1
3. Installation of developing cartridge
1) Open the manual paper feed tray.
2) Lift the knob and slide the side cover gently.
3) Open the front cover.
•
Hold the both edge gently and open the front cover.
4) Remove the screw from the upper section of the insertion port of
the developer cartridge.
5) Shake a new developer cartridge a few times as shown.
•
Shake it horizontally as shown with the arrow.
AR-205