Advertisement
Quick Links
Advertisement
Related Manuals for Schaller Messtechnik humimeter BM2
Summary of Contents for Schaller Messtechnik humimeter BM2
- Page 1 User Manual Biomass moisture meter humimeter BM2 Version 2.3_en © Schaller GmbH 2015...
- Page 2 Measuring procedure 1. Place the scale on an even and sturdy work surface. Place the humimeter BM2 in the centre of the scale. Zero the scale to show 0.00kg. 2. Fill the supplied 13 litre bucket with samples taken from varying locations in sample storage.
- Page 3 ( ) until the appears. 13. To name the saved results press the button. 14. Empty the humimeter BM2 and ensure that no material rests are accumulated in the measuring chamber. Version 2.3_en page 3...
- Page 4 Measuring process of wooden pellets: Measure wooden pellets with the calibration curve “5.0k Pellets”. For this measurement the bucket not has to be full of pellets, you must fill in 5,00 kilograms of wooden pellets every time. Measuring process of dry wood-shavings: Is the 13 litre bucket not big enough for 1,00 kilogram of shavings, the measuring device has to be filled separately (e.g.
- Page 5 Empty 3 For customer calibration Empty 4 For customer calibration To test the humimeter BM2. Not for use of measuring the moisture! reference Selection of the right calibration curve: Below you can find advices for selecting the right calibration curve. If...
- Page 6 Woodchips: standard chips of wood (forest wood chips) according to EN ISO 17225-1 class P16, P31 and P45. Coarse WC: for coarse chips of wood P31 & P45 but with fewer fines. If the weight of the filled 13 litre bucket is under 2,6 kg, the standard wood chips calibration curves (2,4k resp.
- Page 7 Changing batteries Your new device is provided with batteries. Please find enclosed the manual for fitting and changing of batteries: 1.) Press with your finger onto the arrow of the battery cap und pull it back. 2.) Remove the empty batteries. 3.) Put four new batteries in the device.
- Page 8 Keypad symbols Menu level overview Measuring window: Rolling Menu Type selection menu Power ON / OFF Switch upper Switch lower Next calibration curve Save Previouse calibration curve Hold Power off (3 sec.) Watch the saved data Suppliers data Store menu can be added Watch the saved data (logs) Menu:...
- Page 9 The bigger connector has to be connected to a USB slot on your PC. Start the LogMemorizer software on your PC and switch on your humimeter BM2. The data transfer can be started on your humimeter or on the software.
- Page 10 BM2. At first plug in the side of the connector with the close plastic casing at the humimeter BM2. Then switch on the device. Not till then the other side of the cable has to be plugged in at the printer.
- Page 11 Exemption from liability For miss-readings and wrong measurements and of this resulting damage we refuse any liability. This is a device for quick determination of moisture. The moisture depends on multiple conditions and multiple materials. Therefore we recommend a plausibility check of the measuring results. Each device includes a serial number and the guarantee stamp.
- Page 12 IMPORTANT ! please read Most common reasons for miss readings Product temperature out of application range Material below 0°C resp. above +40°C (32 to 104 °F) may cause faulty measurements. The storage of cold material in a warm storage area usually creates condensed water which may lead to major measuring errors.
Need help?
Do you have a question about the humimeter BM2 and is the answer not in the manual?
Questions and answers