Port Mirroring; Broadcast Storm Control; Link Aggregation (Lag); Rapid Spanning Tree (Rstp) - Dell PowerConnect 3348 Release Note

Release notes
Hide thumbs Also See for PowerConnect 3348:
Table of Contents

Advertisement

Console port speed not displayed with
"show line console command"

Port Mirroring

Title
Gigabit ports mirroring in stacking mode
Tagged traffic in port mirroring
Mirroring of PAUSE frames

Broadcast Storm Control

Title
Storm control on G2 port

Link Aggregation (LAG)

Title
Joining a port to a LAG
Port in LAG MAC addresses learning

Rapid Spanning Tree (RSTP)

Title
RSTP port roles indications
Layer3
IP
Title
Ping to self
QoS/ACLQoS
Title
Changing priority-queue command
cancels wrr-bandwidth settings
Editing ACL from CLI
System Firmware Version 1.1.0.42
PowerConnect 3324/3348 Release Notes
Console speed not displayed when "show line console" command is entered from
the CLI interface.
Description
In cases where both source and destination ports are Gigabit ports, some of the
packets may be dropped due to the stacking management traffic.
All traffic on the mirroring target port is always tagged (even if originally it was sent
untagged).
Destination port does not receive PAUSE frames.
Description
Since the G2 stacking port is used for internal management traffic, storm control is
disabled on the G2 stacking port.
Description
Joining a port to a LAG is possible only if:
There is no Layer 3 interface defined on the port.
The port does not belong to any VLAN.
The port does not belong to any other LAG.
The port is not a mirrored port.
The port 802.1p priority is equal to LAGs 802.1p priority.
An ACL is not defined on the port.
QoS Trust is disabled on the port.
GVRP is not enabled on the port.
When a port is a member of LACP LAG under traffic, MAC addresses are learned
on the port until it actually joins to the LAG.
Description
The command show spanning-tree interface does not show RSTP port roles, nor does
the Web-based management.
Description
PowerConnect 3348/3348 cannot ping itself.
Description
Changing the priority-queue out num-of-queues command value leaves any existing
wrr-bandwidth commands.
Once an ACL is bound to an interface it cannot be edited from the CLI
Page 6

Advertisement

Table of Contents
loading

This manual is also suitable for:

Powerconnect 3324

Table of Contents