Installation - Memorex MPH-4495 Operating Instructions Manual

MPH-4495 O/M.QXD 7/9/01
This section has been designed to provide a reference guide to help set up the
unit.
1. Unpack and make sure all the items have been included:
Base Unit, Power Adaptor and Telephone Line Cord(s).
2. Connect one end of the provided telephone line cord into the LINE jack on the
rear of the unit and the other end into a modular telephone jack.
If using a telephone splitter to connect the unit AND an additional phone, plug
the telephone splitter into the modular phone jack and connect the provided
telephone line cord into one jack of the telephone splitter and the additional
telephone's line cord into the other jack.
3. Insert the small plug on the end of the AC adaptor into the DC power jack
located on the rear of your unit. Use only the Center Negative AC adaptor
provided with your unit: INPUT: 120VAC, 60Hz
4. Plug the AC adaptor into a standard 120V AC wall outlet. Once plugged in, the
display will count up from 0 to 6. After a beep, the unit will say,
"ANNOUNCEMENT ON". The battery indicator will light if the battery is dead,
weak, or not installed. Page 7 describes how to install the batteries.
5. This unit uses digital technology, so a microcassette is not used. Follow the
instructions on the following pages to operate your unit.
6. During AC power failure, four (4) AA batteries provides battery backup so the
unit can maintain the memory information. However, the unit cannot answer
incoming calls without AC power.
9:02 AM Page 5

INSTALLATION

E–5
OUTPUT: 8.4V DC