Port Numbers Used For Sentinel 6.1; General Installation Prerequisites - Novell SENTINEL 6.1 SP2 - INSTALLATION GUIDE 02-2010 Installation Manual

3 Open the
ESEC_HOME/config/configuration.xml
4 Locate the entry for the process to move to 64-bit at the end of the file. For each of these
process that should run as 64-bit in the
environment variable to
java
5 Modify the
-Xmx<#>m
you want to allocate additional memory.
Start by doubling the value that was already there for the processes that will be running in a 64-
bit JVM. This is necessary because of the overhead of the 64-bit JVM as described earlier.
Then, modify their values again and choose an even higher number.
6 Save the
configuration.xml
syntax.
7 Start the Sentinel services. Select Start > Control Panel > Administrative Tools > Services,
right-click Sentinel, then select Start.

3.3 Port Numbers Used for Sentinel 6.1

On the Sentinel 6.1 server, configure the following ports in the firewall to enable communication
between Sentinel 6.1 and its components:
Port Numbers for Sentinel 6.1 Server
Table 3-1
Component
Message bus
Sentinel Control Center
proxy
Collector Manager
certificate authentication
The Sentinel Data Manager (SDM) uses port 1521 to connect to the Oracle database and port 1433
to connect to the MS SQL database. These are the default ports that are used, however, you can
change the port numbers.

3.4 General Installation Prerequisites

Perform the following tasks before installing Sentinel. For more information on these prerequisites,
including the list of certified platforms, see
Ensure that each machine in the Sentinel architecture meets the minimum system requirements.

image
$(ESEC_HOME)/jre64/bin/java
setting of the process entries in the
file and open the file in a Web browser to validate the XML
Port Number Description
10012 The port on which the communication server is listening.
Components connecting directly to the communication server
use this port.
10013 The port on which the SSL proxy server (DAS Proxy) is
listening to accept username and password based
authenticated connections. When prompted for a username
and password, it uses this port to connect to the Sentinel
server.
10014 The port on which the SSL proxy server (DAS Proxy) is
listening to accept certificate-based authenticated
connections. Because the Collector Manager cannot prompt
for a username and password, it uses this port to connect to
Sentinel server if it is configured to connect through the proxy.
Chapter 2, "System Requirements," on page
file in a text editor.
attribute, change the
$(ESEC_JAVA_HOME)/
.
configuration.xml
file for which
17.
Installing Sentinel 6.1 SP2 31