7.1.4 Only One eDirectory Instance Is Supported on OES
Servers
If your OES server has multiple instances of eDirectory running (multiple trees), any attempt to
upgrade the server fails.
You must remove all instances, except the one that uses port 524, prior to an upgrade.
For more information, see
7.2 OES 2 SP3 Upgrade Paths
The following are supported upgrade paths for OES 2 SP3:
Supported OES 2 SP3 Upgrade Paths
Table 7-1
Source
OES 1 SP2 (32-bit)
OES 2 SP2 (32-bit)
OES 2 SP2 (64-bit)
NOTE: Physical installations cannot be upgraded to virtual installations, and the reverse is also true.
Only physical to physical and virtual to virtual upgrades are supported.
For complete upgrade instructions, see
Guide.
In addition to upgrading the server itself, data and service migrations from OES 1 to OES 2 are also
supported. For more information, see the
7.3 NetWare 6.5 SP8 Upgrade Paths
For help upgrading from NetWare to OES 2, see the
Guide.
72
OES 2 SP3: Planning and Implementation Guide
Section 6.7.5, "One Instance Only," on page
Destination
OES 2 SP3 (32-bit)
OES 2 SP3 (32-bit)
OES 2 SP3 (64-bit)
"Upgrading to OES 2
OES 2 SP3: Migration Tool Administration
64.
SP3" in the
OES 2 SP3: Installation
OES 2 SP3: Upgrading to OES—Best Practices
Guide.
Need help?
Do you have a question about the OPEN ENTERPRISE SERVER - PLANNING AND IMPLEMENTATION GUIDE 12-2010 and is the answer not in the manual?
Questions and answers