Novell OPEN ENTERPRISE SERVER 2 SP2 - LINUX TIPS FOR NETWARE ADMINISTRATORS Manual page 43

NetWare Command Purpose or Subcommand
SPOOL Create, change or display
spooler mappings.
IMPORTANT: This applies
to NetWare legacy printing
and is no longer
supported.
Start one or more
START
secondary processors
PROCESSORS
when the server is running
on a multiprocessor
computer.
STOP Stop one or more
PROCESSORS secondary processors in a
multiprocessor computer.
SWAP Display information about
swap files, add or delete
swap files, and specify the
parameters of swap files.
Monitor TCP/IP activity
_TCP
and connection status.
TCPCON Monitor TCP/IP activity,
configuration and statistics
information, known routes,
trap log.
Use SNMP to access
TCP/IP information in any
remote protocol stack
supporting the TCP/IP
Management Information
Base (MIB).
TECHWALK Record NetWare
configuration information.
TIME Display date and time,
daylight saving time
status, and time
synchronization
information
Linux Command
Alternatives and Notes
Counterpart
— Legacy NetWare printing has been
replaced by iPrint on both OES
platforms.
— Control of individual processors is
not available as part of OES-Linux.
— Control of individual processors is
not available as part of OES-Linux.
mkswap For more information, see the
respective man pages.
swapon
swapoff
For more information, see the
tcpdump
tcpdump
To watch failovers and errors on
bonded interfaces, use
var/log/messages
netstat For more information, see the
netstat
— Techwalk is not available for OES-
Linux. However, there is a GPL
utility named supportconfig that
collects system troubleshooting
information. For more information,
visit the
(http://www.novell.com/
coolsolutions/tools/16106.html).
date For more information, see the
man page.
man page.
tail -f /
.
man page.
Cool Solutions Web site
date
NetWare/Linux Command Map 43